Universal Air Ride Kits

Universal Air Ride Kits

Get EVERYTHING that you need to hook up air suspension on your vehicle

  • The 3H from Air Lift Performance is both a height and pressure based management that features 5 preset heights and individual four corner air spring control. The height based sensors give the system the ability to automatically re-level when loads change. 

Installed the system but don’t feel like finishing up the height based leveling sensors? Not a problem! Since the 3H system also utilizes pressure sensors, you can drive your car in pressure mode until you find the time to get around to installing the height sensors. 

The 3H’s wired digital controller displays all four bag pressures as well as the tank pressure. The controller uses a full color, backlit screen and features a rotatable keypad that allows for horizontal controller mounting.

    3H Height Management Only

    Airlift Performance

    MSRP: $1,699.99
    $1,399.99
    The 3H from Air Lift Performance is both a height and pressure based management that features 5 preset heights and individual four corner air spring control. The height based sensors give the system the ability to automatically re-level when loads change...
    MSRP: $1,699.99
    $1,399.99
  • AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The ENDO-VTTM also represents AccuAir’s next generation of solenoid valve technology that includes VFCTM (variable flow control) in addition to D.O.T. approved fully filtered and rebuildable ffPTCTM (fully-filtered push-to-connect) fittings. The 3-gallon version has a 2-corner valve-cap on one end of the tank while the 5-gallon version has a 2-corner valve-cap on each end providing 4-corner control. AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The ENDO-VTTM also represents AccuAir’s next generation of solenoid valve technology that includes VFCTM (variable flow control) in addition to D.O.T. approved fully filtered and rebuildable ffPTCTM (fully-filtered push-to-connect) fittings. The 3-gallon version has a 2-corner valve-cap on one end of the tank while the 5-gallon version has a 2-corner valve-cap on each end providing 4-corner control.

    AccuAir Endo-VT Tank | 3 Gallon

    ACCUAIR

    $589.00 - $639.00
    ENDO-VTTM (Valve + Tank)   AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The...
    $589.00 - $639.00
  • AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The ENDO-VTTM also represents AccuAir’s next generation of solenoid valve technology that includes VFCTM (variable flow control) in addition to D.O.T. approved fully filtered and rebuildable ffPTCTM (fully-filtered push-to-connect) fittings. The 3-gallon version has a 2-corner valve-cap on one end of the tank while the 5-gallon version has a 2-corner valve-cap on each end providing 4-corner control. AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The ENDO-VTTM also represents AccuAir’s next generation of solenoid valve technology that includes VFCTM (variable flow control) in addition to D.O.T. approved fully filtered and rebuildable ffPTCTM (fully-filtered push-to-connect) fittings. The 3-gallon version has a 2-corner valve-cap on one end of the tank while the 5-gallon version has a 2-corner valve-cap on each end providing 4-corner control.

    AccuAir Endo-VT Tank | 5 Gallon

    ACCUAIR

    $749.00 - $799.00
    ENDO-VTTM (Valve + Tank)   AccuAir’s patent pending ENDO-VTTM takes streamlined appearance to an entirely new level by integrating the solenoid valves and manifold directly into the air tank end caps themselves. The...
    $749.00 - $799.00
  • Bellows Style Air Spring
9-way adjustable damping
Compressed Length: 13.00" / 12.66"
Extended Length: 19.00" / 18.66"
Finish: Black Powdercoat
Total Stroke: 5.60"
Load Capacity: 1690 lbs. @ 100 PSI
Designed Ride Height: 15.03" – 17.03"

    Extra Long Air Shock

    Airlift Performance

    MSRP: $1,199.99
    $929.99
    Whether you have a custom chassis or hot rod, AirLift Performance has the solution to your air suspension needs. Our SlamAir shocks are designed to mount in place of the coil springs and shocks to give you the ground hugging stance you are looking for...
    MSRP: $1,199.99
    $929.99
  • Basic 3/8 line kit with the following: 1- ViAir 380 Compressor, 1- 5 Gallon Chrome Multiport Tank, 8- 1 way 3/8” SMC Valves, 1- 150psi. Pressure Switch, 1- 10 Switch Pre-wired Box, 1- Single Needle Pressure Gauge, 4- Air Bags, All fittings and 60ft. Air Line.

    FBSS Air Suspension | 3/8" Lines

    ViAir

    $965.99
    In this kit, you have 3/8" line for fill and release, and front, back and side to side. 1- ViAir 380 Compressor 1- 5 Gallon Chrome Multiport Tank 8- 1 way 3/8” SMC Valves 1- 150psi. Pressure Switch 1- 10 Switch Pre-wired Box 1- Single...
    $965.99
  • On Sale
    FRONT TO BACK MANUAL SETUP

(1) VIAIR 380C COMPRESSOR
(1) 5-GALLON 6-PORT TANK (BLACK OR SILVER)
(2) PNEUMATIC SWITCH AIR RIDE
(1) 50' OF 1/4" NYLON D.O.T. AIR LINE
(1) 200psi PRESSURE SWITCH
(2) 1/4" 3-WAY PLASTIC PUSH CONNECT TEE
(6) 1/2" x 1/4" REDUCING BUSHING
(2) 1/4" LINE x 1/4" PIPE MALE PLASTIC PUSH CONNECT ELBOW
(4) 1/4" x 1/4" MALE PLASTIC PUSH CONNECT STRAIGHT
(1) 1/4" PIPE DRAIN COCK
(1) 1/4" HEX PLUG
(1) WIRING KIT
(1) DUAL NEEDLE GAUGE WITH AIRLINE & FITTINGS

***IN ADDITION TO THE KIT ABOVE YOU'LL RECEIVE THE FOLLOWING ITEMS FOR FREE!!! $55 VALUE!!!***

(1) WATER TRAP WITH 1/4" PORTS (BLACK OR SILVER)
(1) 1/4" HEX NIPPLE
(1) COMPRESSOR MOUNTING PLATE

    Front to Back Manual Air Kit

    Airlift Performance

    MSRP: $799.99
    Now: $649.99
    Was: $699.99
    FRONT TO BACK MANUAL SETUP (1) VIAIR 380C COMPRESSOR (1) 5-GALLON 6-PORT TANK (BLACK OR SILVER) (2) PNEUMATIC SWITCH AIR RIDE (1) 50' OF 1/4" NYLON D.O.T. AIR LINE (1) 200psi PRESSURE SWITCH (2) 1/4" 3-WAY PLASTIC PUSH CONNECT TEE (6) 1/2" x...
    MSRP: $799.99
    Now: $649.99
    Was: $699.99
  • Whether you have a custom chassis or hot rod, AirLift Performance has the solution to your air suspension needs. Our SlamAir shocks are designed to mount in place of the coil springs and shocks to give you the ground hugging stance you are looking for while retaining driveability.

Our double bellow style SlamAir shocks are normally used in the front of a vehicle in order to support the weight. While the sleeve style SlamAir shocks can be found in the rear to ensure the best possible ride quality. Along with the ability to adjust height, these twin tube shocks also have 9 different damping settings to fine tune the ride comfort and handling performance to your personal taste.

With four different lengths and multiple end mounting options, Air Lift Performance SlamAir shocks can be tailored to fit almost any application!

Features

Bellows Style Air Spring
9-way adjustable damping
Compressed Length: 11.45" / 11.11"
Extended Length: 17.03" / 16.69"
Finish: Black Powdercoat
Total Stroke: 5.18"
Load Capacity: 1730 lbs. @ 100 PSI
Designed Ride Height: 13.9" – 15.0"

    Long Air Shock

    Airlift Performance

    MSRP: $1,199.99
    $929.99
    Whether you have a custom chassis or hot rod, AirLift Performance has the solution to your air suspension needs. Our SlamAir shocks are designed to mount in place of the coil springs and shocks to give you the ground hugging stance you are looking for...
    MSRP: $1,199.99
    $929.99
  • Whether you have a custom chassis or hot rod, AirLift Performance has the solution to your air suspension needs. Our SlamAir shocks are designed to mount in place of the coil springs and shocks to give you the ground hugging stance you are looking for while retaining driveability.

Our double bellow style SlamAir shocks are normally used in the front of a vehicle in order to support the weight. While the sleeve style SlamAir shocks can be found in the rear to ensure the best possible ride quality. Along with the ability to adjust height, these twin tube shocks also have 9 different damping settings to fine tune the ride comfort and handling performance to your personal taste.

With four different lengths and multiple end mounting options, Air Lift Performance SlamAir shocks can be tailored to fit almost any application!

Features

Bellows Style Air Spring
9-way adjustable damping
Compressed Length: 10.05" / 9.71"
Extended Length: 14.23" / 13.89"
Finish: Black Powdercoat
Total Stroke: 3.78"
Load Capacity: 1840 lbs. @ 100 PSI
Designed Ride Height: 11.5" – 12.5"

    Medium Air Shock

    Airlift Performance

    MSRP: $1,199.99
    $929.99
    Whether you have a custom chassis or hot rod, AirLift Performance has the solution to your air suspension needs. Our SlamAir shocks are designed to mount in place of the coil springs and shocks to give you the ground hugging stance you are looking for...
    MSRP: $1,199.99
    $929.99